Receiver Mods:

Channel Change Mod
Author: Bluetwo
Author Email: Bluetwo at RCGroups
Specs: Shows you how to change the reciever channel
Material Required: None
Downloads available:
Notes: There is a solder pad jumper on the front side of the rx board, labelled B - C, if neither are connected it runs on channel A. Same sort of set up as the x-twin, aeroace

Default Connections
Author: MegaTesla
Author Email: MegaTesla at RCGroups
Specs: Describes Rx Connections
Material Required: None
Downloads available:
Notes: For the tail motor: One of the tail motor wires is red, the other is copper coloured. Red one is soldered to + of the battery, the other one is soldered to the M1 pad.

Throttle Glitch Solution
Author: poulsbobill
Author Email: poulsbobill at RCGroups
Specs: Shows you how to make a resistor for better motor control
Material Required: Light wire
Downloads available:
Notes: Nice mod for a fix to the full charge problem!